Ebode TAKE 6 IR/RF Guide de l'utilisateur télécharger pdf (Page 13)

13-3-2014 13 ebode TAKE6 IR/RF

• Set the remote back to factory default.

How to set the TAKE 6 Remote back to factory default

• Press and hold S (8) until the LED indicator (2) lights

steadily. Release S.

• Press and hold S (8) until the LED indicator (2) lights

steadily. Release S.

• Press and release the 0 key (14) once.

• Press and release the S key (8).

• The LED (2) turns off after few seconds.

6. Tips & Tricks about learning IR codes to a remote

When learning IR codes always test the IR codes directly

during the learning process.

In this way you do not need to learn all the codes over

and over again.

Please try the following steps when the learned IR code

fail to work.

1. Make sure the original remote you are learning the

code from has a fresh set of batteries. (preferably

Duracell or Energizers)

2. Increase/decrease the distance between the two

remotes when learning. (original and URC)

Try for example to double the distance, up to 4 feet is

possible.

3. For ‘normal’ short burst codes, try to ‘tap’ the button

instead of press and holding it.

4. For ‘Continuous’ codes, try the ‘flicker’ technique –

rapidly tap the button while learning. (approximately

7x per second or faster.)

5. Try the ‘Swoop’ method, Start form 2’ away and then

‘swoop’ the remote towards the learning remote.

6. Try the ‘Flasher’ method. Hold an opaque object in

front of the remote and remove it then quickly

replace it.

7. Try learning the codes to another learning remote

first, and then from that remote to the required one.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Pas de commentaire

Ebode TAKE 6 IR/RF Guide de l'utilisateur Page 13